Casella-cel CEL-310 Manual de usuario descargar pdf (Pagina 21)

A Calibration ok message is displayed when calibration has

been completed satisfactorily.

If the calibration cannot be completed sucessfully, the Reader

may display one of the following error messages:

Too high

Too low

Badge running.

Refer to Chapter 6: Troubleshooting for assistance.

4.2 Reset the Dose Badge

All dose badges to be used for the measurement task must have their

data stores reset to zero, before new measurements can be made.

Install the Dose Badge in the calibrator cavity with infrared

windows oriented as described in Section 4.1 (Figure 5).

1. If not already on, press to switch the Reader ON.

2. Wait for the status screen to be displayed, then press to

initiate the Reset sequence.

C-02

Calibrated to 114 dB

Calibrating . . . . ok

Reset

C-03

Reset Noise Badge

OK Cancel

Reset progress

C-04

Resetting . . . . ok

Operation

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 44 45

Sin comentarios

Casella-cel CEL-310 Manual de usuario Pagina 21